
03-28-2010, 12:23 AM
|
 |
Senior Member
|
|
Join Date: May 2006
Location: New Jersey, USA
Posts: 1,399
Classified Rating: 0% (0)
|
|
Ok, so is the temperature reading from the probe or is it from the thermostat? Is the probe placed on the heat tape or on the tile? Is this temperature of 100 the surface temp of the tiles, say taken with an accurate temp gun? These are the questions that you need to think about. If your thermostat is set to 100F for instance, and your heat probe for this thermostat is directly on the heat tape/heat chord/heating pad (which it should be) then the tape/chord/pad is 100F on its' surface. This means that the tiles which are on top of this heating devise is significantly less warm. I would suggest getting a very good heat gun(the cheap one's aren't very accurate, or they get worse with age) as it is always really good to double check the temps in the enclosure and it is good not to take the thermostats word for the temp as it can be off. Like I was saying, set the thermostat/rheostat up and take the temp of the surface the gecko will be on, and adjust as necessary. This investment in a temperature gun will be soo very worth it for you and it will save you so much of a headache, and you will have no questions as you will know exactly how warm the surface of your tiles or your sand or your paper towels/substrate of any sort, etc. is at any given time with the press of a button. Hope this helps you out!
|