Recent content by killuminati

k im kinda confused where to put the little probe for my thermometer. i have an UTH on the side of my exo-terra and a then the leaves in the corner. so should i put the probe in the leaves or on the glass. he usually chills on the glass against the UTH.

k its been around a month and my gecko has only had like 5 mealworms and it wont eat. the temp on the warm side are 91-95 and i have tile. I feed it crickets, mealworms and superworms. It has pooped 2 times in the past month. It will go to eat then lick the worms then looses interest. Its about...

I just finished my rock wall but im not completly happy with it, anyways here it is. Sorry for the horrible pics. I took them with my phone.

Im thinking about getting a gargoyle gecko because they are such beautiful geckos. anyways theres this one at my local petstore for, i think it was like 270-300. Isnt that a bit over priced? Now i dont know anything about gargoyle morphs except for stripes and blotches. Same idea as the one in...

I made a background out of styrofoam and i have it grouted already but no paint or sealer. Is it safe to put in my tank?

I am using repcal calcium with d3 and just found out that to much is bad for them. I have it in a calcium dish, but I dust with mardels herpcare cricket dust, so is that fine or should I take out the dish until I get normal calcium without D3? And should I dust with mardels herpcare crickets...

I have both but dont know what one to use. Im building a background for my leopard gecko. I tried using grout on different styrofoam but it just crisped off after a couple layers and days drying, so im kinda afraid to use it now. The styrofoam I am using now is polystyrene.

I need a new heat source and im wondering what one to get. I dont know much about the ceramic heat emitter but that it heats the air and the floor. What is better and why? P.S I would probably get the infared heat emitter

I plan on breeding in a couple months (like 5 or 6) but im gonna wait till I get more experience. How hard is it to sell babies? Could I sell them in the classifieds here? What should I breed my bell albino with to get some nice looking babies?

k I was building two hides made out of styrofoam, then i put 3 layers of grout on it, 2 days later it's still crumbly and and I could probably easily crush it with my hand. What did i do wrong. I was going to make a background but ill have to find a better way to do it. Whats the easiest way to...

1. My humidity is at around 70. I have no idea why, I have a full screen top and a water bowl and humid hide on the cold side. How can I bring it down? 2. What water should I use, tap water or bottled water. Does it matter. Im currently using bottled. 3. I know mealworms arn't that...

I am going make a fake background and hides for my leopard gecko. Do i need a sealant on it or can i just puet the grout and paint on?

I know I dont have a calcium dish and a humid hide but im getting them tomorrow. Any constructive criticism would be great. I will also try and get better pics. I also have some mardels herpcare cricket dust, could I use that in the calcium dish. Can anyone tell me the morph? Im thinking tremper...

I got this bag from a friend when i bought his old gecko stuff and it says "naturally spherical grains wont scratch reptiles inside or out". Now I know about impaction and how man made square sand causes impaction but would this be as bad and a bit easier to digest? Maybe even more if it was...

I wanna get a blue nightglow bulb but some people said leopard geckos can see it at night and it hurts there eyes, is that true? what would be better to get the blue one or red one?