New Leopard Gecko Owner

ccapasso

New member
How are temps measuring up with shelf liner as the substrate? Has Anthem adapted to the new arrangement of his hides?


Temps are better for sure. About 88-90 inside the warm hide. Ambient is lower 80-82 I believe (going off memory), cool hide around 70-72.

I still have to put on the new Ultratherm UTH (it came in, just haven't had the opportunity to do so). Thinking I may get to it tonight.

He seems to be adjusting well to the rearrangement. Coming out more and eating very good still.

I just ordered a good bit of decorations (fake plants, wood, etc) to help fill things up and add some clutter.
 

Elizabeth Freer

Well-known member
Soon Anthem will have a much warmer home. I hope that helps him be out and about even more!

BTW, are you using the baggy method to dust or have you discovered an easier way?
 
Last edited:

ccapasso

New member
Slate and sealer was purchased but not yet put in. Couple of questions first:

How long after sealing do you let the slate cure before putting in tank?
If sand is needed under the slate (to make it lay even/flat) how much and what type of sand is good to use ?
 

Elizabeth Freer

Well-known member
Soon Anthem will have a much warmer home. I hope that helps him be out and about even more!

BTW, are you using the baggy method to dust or have you discovered an easier way?

Instead of the cumbersome baggy supplement method, place a small amount of each supplement into separate tall 32 ounce deli containers. Label by colors: orange, blue, & green. Add crickets or mealworms. Then swirl them to lightly cover them. Then bounce them against the bottom of the container to shake off excess powder. Feed off to leo. Tightly cap this container to preserve the supplement until the next feeding.

Slate and sealer was purchased but not yet put in. Couple of questions first:

How long after sealing do you let the slate cure before putting in tank?
If sand is needed under the slate (to make it lay even/flat) how much and what type of sand is good to use ?

I haven't sealed my slate yet. I really do have two 16 x 2 inch slate cheese trays. I'm not using them until I seal them.

Do the directions on the sealant say? Maybe cure the sealant for several days?

What you don't want are any air pockets between your Ultratherm and the slate. Purchase just a small bag of regular play sand. Rinse off the dust and spread it on a towel to dry. All you need is a small amount of clean play sand to fill in the voids to make the slate level.
 
Last edited:
Top